Precautions for inspection before using multi-axis tapping machine

1. Check the multi-axis tapping machine before use: whether the chuck is good and whether the work surface is parallel; push up the main power switch.

2. Multi-axis tapping start-up steps: main motor operation: turn the motor operation button to positive or reverse operation to make the motor rotate forward or reverse; operation method selection: select forward operation and reverse operation operation methods according to operation requirements; forward operation :Put the motor operation button to the normal running position, which can make the motor run forward to drive the drill bit movement. It is used to shake the handle wheel to feed the drill bit downward. The handle wheel will automatically spring back when the handle is released; reverse operation: run the motor Push the button to the reverse running position, you can make the motor rotate reversely and turn the handle to work.

3. Matters needing attention in the use of multi-axis tapping machine: the drill fixture cannot be knocked, it needs to be tightly fixed with a wrench or the drill; when drilling, it should be noted that the drill cannot be drilled to the platform or fixture; when drilling, the position where the workpiece is drilled must be given first Set a center point; when the drilling diameter is greater than 10MM, it should be divided into 2-3 times from small to large drilling; the speed of the drilling machine is adjusted according to the size of the drill bit. The pulley is adjusted according to the size of the drill bit. If it is too small, it needs to be fixed with a jig. Do not use your hands to stabilize the work; do not wear gloves when working.

4. Stopping steps of multi-axis tapping machine: When noon rest, work or stop working, the drilling machine should be placed in a safe stop state; operation stop: put the motor operation button to the OFF position to stop it; cut off the power supply: Pull down the main power switch.

5. Frequently drain the air compressor. The air compressor must be drained frequently. If the air compressor has too much water and it is not drained in time, it will be brought into the air motor. After a long time, the bearing becomes inflexible.

6. The oil cup (the cup on the right) of the double joint must be filled with oil. As long as the air motor of the pneumatic tapping machine is composed of bearings and gears, it needs lubrication. With more fuel, the work is flexible and the tapping machine is durable.

From: http://www.hi-pre.com/precautions-inspection-using-multi-axis-tapping-machine/

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *